Your Choice: 38/2 or 38/8
Frame is shipped raw - painted for picture only
Material:
1020 DOM
(Drawn Over Mandrel) steel tubing.
Downtube legs are 1-3/8” O.D. with .120
wall thickness for double downtube frames.
Downtube is 1-3/4” O.D. for singe downtube frames.
Cradle tubes are 1-3/8” O.D. for singe downtube frames.
Backbone is 1-1/2” O.D. with .219 wall thickness.
Seat post is 1-1/2” O.D. with .219” wall thickness.
Special features:
TIG Welded. Accepts 13” fender and 1984 & later flat side gas tanks.
Accepts Softail® style oil tank.
Accepts 300 rear tire with full width 1.5” belt.
Integral 5th bolt
mounting within
reinforced offset trans plate.
Included additionally:
Heavy Duty Swing Arm, 1” hidden axle.
Front oil tank mount.
Rear frame pivot tube and hardware
including pivot bearings & spacers.
NOTE 1: Coil mounts and regulator mounts must be determined by builder.
NOTE 2: Backbone is measured from back of neck to front of seat plate gusset. Downtube is measured from bottom of neck to top of cradle tube joint.
***Motorcycles modified with some aftermarket parts, accessories and performance engine parts may be restricted from use on public roads and/or limited to closed courses. Please see U.S. EPA and your respective state regulations. We advise having all parts installed by a qualified motorcycle mechanic for safety and proper installation.***
